Surefire KL6 Lumamax Upgrade

This engine is a bolt on replacement for the factory light engine.  The XML2 engine is powered by 1x 3.7V li-ion cell.  The XHP50 is powered by 2x 3.7V IMR li-ion cells.   No other combinations will work.  Non rechargeable lithium batteries will not work.  This is a light engine only NO head or body are included.


USER INTERFACE:

None other than Dr.Jones Guppy2drv.  The ultimate in flexibility.   This UI offers a wide range of modes to choose from.  Something for almost any occasion.

User Selectable Groups:

1. 1% - 25% - 100% | Memory
2. 1% - 25% - 100% | No Memory
3. 100% - 25% - 1% | No Memory
4. 1% - 25% - 100% - Strobe | No Memory
5. 1% - 25% - 100% - Strobe | Memory
6. 10% - 100% | Memory
7. 10% - 100% | No Memory
8. 100% - 10% | No Memory
9. 100%
10. 100% - Strobe | No Memory
11. Strobe - 100% | No Memory
12. ML - 2% - 25% - 100% | Memory
13. ML - 2% - 25% - 100% - Strobe - Beacon | No Memory
14. ML - 100% | No Memory
15. 100% - ML | No Memory
16. ML - 100% | Memory
17. ML - 1% - 5% - 15% - 40% - 100% | Memory
18. ML - 1% - 5% - 15% - 40% - 100% | No Memory
19. 100% - 40% - 15% - 5% - 1% - ML | No Memory
20. 100% - 40% - 15% - 5% - 1% - ML | Memory
21. 1% - 5% - 15% - 40% - 100% | Memory
22. 1% - 5% - 15% - 40% - 100% | No Memory
23. 100% - 40% - 15% - 5% - 1% | No Memory
24. 100% - 40% - 15% - 5% - 1% | Memory

Guppydrv ​Instructions

To switch mode groups: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch the same number of times as your desired mode group. The light will blink and your mode group will be memorized.

Example: To select mode group 3, tap the switch 8 times quickly to enter programming mode. As soon as the light enters programming mode and beings flashing, tap the switch three times. The light will blink to recognize the mode group change.

To set the turbo timer: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch 30 times to enter the turbo timer set mode. The light will then switch to 100% power. When the light is at the desired temperature for the turbo step down, turn the light off. The turbo timer will then be set. The turbo timer steps the light down to 50% regardless of the mode group set.

To disable the turbo timer simply go into program and cut it off in >3 seconds.