-Cree XHP-70 LED
-2 x IMR li-ion powered ( batteries not included)
-Custom user interface (mode choices)
-Copper core for maximum heat transfer
-Nickel plated for lasting shine
This product is no longer in stock
Warning: Last items in stock!
These bulbs are for Surefire® 6P. They will also work in a variety of other P60 hosts, but use of copper tape may be required to ensure proper heat transfer.
Now in nickel plated copper. Copper will tarnish over time but the nickel finish remains bright for a lifetime.
LED: Cree XHP-70
Power source: 2x li-ion ONLY ( batteries NOT included)
For non bored bodies IMR 16340s or 17670s.
DO NOT USE lithium primary cells.
DO NOT USE standard NON IMR 16340s or 18350s.
Custom built Mosfet driver board which is essentially direct drive giving much higher currents than traditional 7135 boards, up to 7+ amps depending on emitter VF and what cells are used.
This firmware allows the ultimate in user customizability, with 24 built-in mode groups, that the user can select via a series of button presses and the option of user programmable turbo timer that will automatically step the power down to 50% after the set time is hit (see below for instructions).
User Selectable Groups:
To switch mode groups: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch the same number of times as your desired mode group. The light will blink and your mode group will be memorized.
Example: To select mode group 3, tap the switch 8 times quickly to enter programming mode. As soon as the light enters programming mode and beings flashing, tap the switch three times. The light will blink to recognize the mode group change.
To set the turbo timer: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch 30 times to enter the turbo timer set mode. The light will then switch to 100% power. When the light is at the desired temperature for the turbo step down, turn the light off. The turbo timer will then be set. The turbo timer steps the light down to 50% regardless of the mode group set.
To disable the turbo timer simply go into program and cut it off in >3 seconds.
Adventure Sport Flashlights is not affiliated with Surefire®, nor are its products made or endorsed by them.
Please note: These bulbs are very high powered and have the potential to cause fire, eye injury, burning of skin and other. Adventure Sport Flashlights is NOT responsible for accidents or damage including but not limited to fire or personal injury due to mishandling or misuse. By purchasing product you agree to these terms.
* required fields