Fits Aleph head for with Surefire E series and compatible
Complete engines fully assembled and tested
3x XM-L2 2,200 lumen
3x XHP-50 5,000 lumen
Warning: Last items in stock!
|2||$145.80||Up to $32.40|
|3||$137.70||Up to $72.90|
|5||$126.36||Up to $178.20|
Madness! The unthinkable is here. Choose from single cell and multi cell options.
These engines have a solid copper core, coupled with a direct thermal path copper MCPCB, and Crees industry leading LED emitters XM-L2 or XHP-50.
3 of each emitter rest on the slug utilizing optics with a specific viewing angle for the absolute best quality beam possible. Both engines have an exquisite profile, and NO doughnut or article in the center even using the quad die emitter. Much though was put into the design of this engine to ensure performance.
XML2 engines powered by 1x IMR 18650 or IMR 17670
XHP-50 engines powered by 2x IMR 18350s
2 IMR 16340s or 2x IMR18650s
Outputs of 2,200 and 5,000 will vary based on choice of emitter and batteries used These numbers are for reference only.
Custom built Mosfet driver board which is essentially direct drive giving much higher currents than traditional 7135 boards, up to 7+ amps depending on emitter VF and what cells are used. Two user interface options are available with this model.
DrJones Guppy2drv. This firmware allows the ultimate in user customizability, with 24 built-in mode groups, that the user can select via a series of button presses and the option of user programmable turbo timer that will automatically step the power down to 50% after the set time is hit (see below for instructions).
User Selectable Groups:
To switch mode groups: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch the same number of times as your desired mode group. The light will blink and your mode group will be memorized.
Example: To select mode group 3, tap the switch 8 times quickly to enter programming mode. As soon as the light enters programming mode and beings flashing, tap the switch three times. The light will blink to recognize the mode group change.
To set the turbo timer: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch 30 times to enter the turbo timer set mode. The light will then switch to 100% power. When the light is at the desired temperature for the turbo step down, turn the light off. The turbo timer will then be set. The turbo timer steps the light down to 50% regardless of the mode group set.
To disable the turbo timer simply go into program and cut it off in >3 seconds.
Here is a short video on how this UI works.
USER INTERFACE OPTION 2
Adventure Sport UI™
The UI consists of 4 groups.
1. Ramp mode low to high with memory.
2. Low 2%, Med 25%, High 100% with memory.
3. Low 2% Med 25%, High 100%, Strobe, SOS, Beacon, NO memory.
4. High 100%, Low 15%. NO memory.
The light will come preset to your choice of group if needed.
Mode groups are switched by 8 fast clicks <.25 sec.
Here is a video of the UI in action.
No customer reviews for the moment.